Skip to content

How To Replace License Plate Bulb

To replace a license plate bulb, first locate the burned out bulb. On most vehicles, the license plate light is located in the rear bumper. Once the burned out bulb has been located, twist it counterclockwise to remove it from the socket. Insert the new bulb into the socket and twist it clockwise to secure it. Finally, test the new bulb to ensure it is working properly.

5 Steps to Replace License Plate Bulb

If one of your license plate bulbs burns out, you’ll need to replace it. You can do this yourself in just a few minutes. Start by prying off the lens cover with a flathead screwdriver. Then, remove the burned-out bulb and insert a new one. Finally, put the lens cover back on and you’re done!

In today’s world, it is more important than ever to know how to replace license plate bulb. With the ever-increasing cost of living, it is important to be able to save money wherever possible. Replacing a license plate bulb is a relatively simple and inexpensive task that can be easily done at home. By knowing how to replace license plate bulb, you can avoid the hassle and expense of taking your car to the mechanic.

Step 1: Replace The License Plate Light Bulb

To replace the license plate light bulb, first remove the screws that hold the light housing in place. Next, pull the housing away from the car’s bumper. Disconnect the electrical connector, and then remove the old bulb. Insert the new bulb, reconnect the electrical connector, and then reattach the light housing.

Step 2: Use A Screwdriver To Unscrew The Light Cover

To unscrew the light cover, use a screwdriver to remove the screws holding it in place. Be careful not to drop the screws, as they can be difficult to find if they fall into the engine bay. Once the screws are removed, pull the light cover off of the light assembly.

Step 3: Remove The Old Light Bulb

Remove the old light bulb by unscrewing it from the socket and then pull it out. Be careful not to touch the new bulb with your fingers because the oil from your skin can cause it to burn out prematurely.

Step 4: Insert A New Light Bulb

To replace a license plate light bulb, first remove the lens cover by unscrewing it. Then, twist out the old bulb and insert a new one in its place. Finally, screw the lens cover back on.

Step 5: Screw The Light Cover Back On

After the new bulb is in, simply screw the light cover back on. Make sure it’s tight so that moisture can’t get in and cause the new bulb to burn out prematurely.

Frequently Asked Questions

Why Are My Plate Lights Not Working?

There are a few things that could cause your plate lights not to work. One possibility is a blown fuse. Another possibility is a bad light bulb. Finally, the wiring could be defective. If you are not sure what is causing your plate lights not to work, you should take your vehicle to a mechanic to have it inspected.

Does Autozone Install License Plate Lights?

Yes, Autozone installs license plate lights.

In Closing

Replacing a license plate light bulb is a simple task that can be completed in a few minutes. The light bulbs are usually located in the center of the license plate. The old light bulb can be unscrewed and replaced with a new one.

Leave a Reply

Your email address will not be published. Required fields are marked *